Journals / Politeknik Dergisi / 2018 / Cilt: 21 - Sayı: 4

The Analysis of Inhomogeneous Barrier Height in In/SnTe/Si/Ag Diode

In/SnTe/Si/Ag Diyotunda Homojen Olmayan Engel Yüksekliği Analizi

Pages
919–925
Publication Date
2022-10-18
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Distribution of the interface states ( ) were extracted from the I-V characteristics and found in increasing behavior with decreasing temperature.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:SnTe thin film layer was fabricated by magnetron sputtering technique on n-Si substrate, and the electrical properties of the In/SnTe/Si/Ag diode structure was investigated by using temperature dependent forward bias current-voltage (I-V) measurements.
📊
Key Findings & Data:The main diode parameters were calculated according to the thermionic emission (TE) model and they were found in an abnormal behavior with change in temperate in which zero-bias barrier height ( ) increases and ideality factor ( ) decreases with increasing temperature.
💡
Conclusion & Impact:Distribution of the interface states ( ) were extracted from the I-V characteristics and found in increasing behavior with decreasing temperature.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

SnTe thin film layer was fabricated by magnetron sputtering technique on n-Si substrate, and the electrical properties of the In/SnTe/Si/Ag diode structure was investigated by using temperature dependent forward bias current-voltage (I-V) measurements. The main diode parameters were calculated according to the thermionic emission (TE) model and they were found in an abnormal behavior with change in temperate in which zero-bias barrier height ( ) increases and ideality factor ( ) decreases with increasing temperature. Therefore, the total current flow though the junction was expressed by the Gaussian distribution (GD) of barrier height. The plot of vs showed the existence of inhomogeneous barrier formation and evidence for the application of Gaussian function to identify the distribution of low barrier height patches. The mean barrier height was found as 1.274 with the 0.166 eV standard deviation. From the modified Richardson plot, Richardson constant was calculated as 119.5A/cm2K2 in very close agreement with the reported values. Additionally, the effects of the series resistance ( ) were analyzed by using Cheung’s function. Distribution of the interface states ( ) were extracted from the I-V characteristics and found in increasing behavior with decreasing temperature.

Özet

SnTe ince film katmanı magnetron saçtrıma tekniği ile n-Si alttaş üzerine büyütüldü, ve In/SnTe/Si/Ag diyot yapısının elektriksel özellikleri, sıcaklık bağımlı düz besleme akım-voltaj (I-V) ölçümleri kullanılarak incelendi. Temel diyot parametreleri termiyonik emisyon (TE) modeli temel alınarak hesaplandı ve sıcaklık artışı ile sıfır-potansiyel engel yüksekliğinin (Φ B0 ) artışı ve idealite faktörünün (n) azalışı gibi ideal olmayan bir davranışta oldukları bulundu. Bu nedenle, eklemdeki toplam akım iletimi, engel yüksekliğinin Gauss dağılımı (GD) ile açıklandı. Φ B0 vs q ⁄ 2kT eğrisi, yapıdaki homojen olmayan engel oluşumunu ve GD kullanılarak düşük bariyerli local bölgelerin dağılımının açıklanabileceğini gösterdi. 0.166 eV standart sapma ile birlikte ortalama engel yüksekliği 1.274 eV olarak bulundu. Etkin Richardson eğrisinden, Richardson sabiti, literatürdeki değerlere yakın bir değerde, 119.5A/cm 2 K 2 olarak hesaplandı. Ayrıca, Cheung fonksiyonu kullanılarak yapıdaki seri direnç (R S ) etkisi analiz edildi. Arayüzey durumların yoğunluğu (D it ) diyot yapısının I-V karakteristiğinden elde edildi ve azalan sıcaklık değerlerine göre artış yönünde bir davranış gösterdiği bulundu.

🔖

Cite This Article

GÜLLÜ, H. H., YILDIZ, D. E. (2022). The Analysis of Inhomogeneous Barrier Height in In/SnTe/Si/Ag Diode. Politeknik Dergisi, Cilt: 21 - Sayı: 4, 919–925. https://ajindex.com/articles/588494

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (14)

  1. Lewis, D.J., Kevin, P., Bakr, O., Muryn, C.A., Malik, M.A., Brien, P.O., “Routes to tin chalcogenide materials as thin films or nanoparticles: a potentially important class of semiconductor for sustainable solar energy conversion”, Inorg. Chem. Front., 1: 577-598 (2014).
  2. Thompson, J.R., Ahmet, I.Y., Johnson, A.L., Kociok- Köhn, G., “Tin(IV) Chalcogenide Complexes: Single Source Precursors for SnS, SnSe and SnTe Nanoparticle Synthesis”, Eur. J. Inorg. Chem., 2016 (28): 4711–4720, (2016).
  3. Tugluoglu, N., Karadeniz, S., Sahin, M., Safak, H., “Temperature dependence of current–voltage characteristics of Ag/p-SnSe Schottky diodes”, Appl. Surf. Sci., 233: 320–327, (2004).
  4. Safak, H., Sahin, M., Yuksel, O. F., “Analysis of I-V measurements on Ag/p-SnS and Ag/p-SnSe Schottky barriers”, Solid-State Electron., 46: 49-52, (2002).
  5. Reddy, K.T.R., Reddy, N.K., Miles, R.W., “Photovoltaic properties of SnS based solar cells”, Sol. Energy Mater. Sol. Cells, 90: 3041–3046, (2006).
  6. Abd El-Rahman, K.F., Darwish, A.A.A., El-Shazly, E.A.A., “Electrical and photovoltaic properties of SnSe/Si heterojunction”, Mater. Sci. Semicond. Process., 25: 123-129, (2014).
  7. Reddy, N. K., Reddy, K.T.R., “SnS films for photovoltaic applications: Physical investigations on sprayed SnxSy films”, Physica B, 368: 25–31, (2005).
  8. Gu, S., Ding, K., Pan, J., Shao, Z., Mao, J., Zhang, X., Jie, J., “Self-driven, broadband and ultrafast photovoltaic detectors based on topological crystalline insulator SnTe/Si heterostructures”, J. Mater. Chem. A, 5: 11171- 11178, (2017).
  9. Zhang, H., Man, B., Zhang, Q., “Topological Crystalline Insulator SnTe/Si Vertical Heterostructure Photodetectors for High-Performance Near-Infrared Detection”, ACS Appl. Mater. Interfaces, 9: 14067−14077, (2017).
  10. Shu, T., Ye, Z., Lu, P., Chen, L., Xu, G., Zhou, J., Wu, H., “Band alignment at the interface of PbTe/SnTe heterojunction determined by X-ray photoelectron spectroscopy”, Europhys. Lett., 116: 37006, (2016).
  11. Sze, S.M., Physics of Semiconductor Devices, Wiley, New York, 1981.
  12. Card, H.C., Rhoderick, E.H., “Studied of tunnel MOS diodes – I. Interface effects in silicon Schottky diodes”, J. Phys. D: Appl. Phys., 4: 1589-1601, (1971).
  13. Ozer, M., Yıldız, D.E., Altındal, S., Bulbul, M.M., Temperature dependence of characteristic parameters of the Au/SnO 2 /n-Si (MIS) Schottky diodes”, Solid State Electron., 51: 941–949, (2007).
  14. Yıldız, D.E., Altındal, S., Kanbur, H., “Gaussian distribution of inhomogeneous barrier height in Al/SiO 2 /p-Si