Journals / İstanbul Üniversitesi Orman Fakültesi Dergisi Seri B / 2008 / Cilt: 58 - Sayı: 2

Effects of knots on the physical and mechanical properties of wood

Budakların odunun fiziksel ve mekanik özellikleri üzerine etkileri

Pages
1–13
Publication Date
2022-10-18
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

But, sorption (shrinkage and swelling), modulus of elasticity in bending, bending strength, comppression strength and impact bending decreased.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this paper, the effects of knots on physical and mechanical properties of wood systematically were summarized.
📊
Key Findings & Data:Results of studies expressed that density, shear strength and hardness of wood specimens increased as knot area in the cross sections increased.
💡
Conclusion & Impact:But, sorption (shrinkage and swelling), modulus of elasticity in bending, bending strength, comppression strength and impact bending decreased.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

In this paper, the effects of knots on physical and mechanical properties of wood systematically were summarized. In general, effects of knots on physical and mechanical properties of wood depend on three factors; deviation of wood fibers surrounding the knots from longitudinal axis, fibers of knots which are perpendicular or a definite angle to wood fibers and cracking due to extreme shrinkage of the knot woods during drying. Results of studies expressed that density, shear strength and hardness of wood specimens increased as knot area in the cross sections increased. But, sorption (shrinkage and swelling), modulus of elasticity in bending, bending strength, comppression strength and impact bending decreased.

Özet

Bu çalışmada, budaklılığın odunun fiziksel ve mekanik özellikleri üzerine etkileri ile ilgili yapılmış bulunan bir dizi çalışma gözden geçirilerek, elde edilen bulgular sistematik bir şekilde özetlenmiştir. Budakların fiziksel ve mekanik özelliklere etkisi genel olarak üç faktöre bağlanır; budakların çevresinden geçen liflerin yönünün gövde boyuna ekseninden ayrılması, budak odununun kendi liflerinin gövde odununun liflerine dik ya da belirli bir açıda bulunması ve kuruma sonucunda budak odununun fazla miktarda daralarak çatlaması. İncelenen çalışmalarda genel olarak budak oranının artması ile odunun yoğunluğu, makaslama direnci ve sertliğinin arttığı, çalışma (daralma ve genişleme) eğilmede elastikiyet modülü, eğilme direnci, basınç direnci ve dinamik eğilme direncinin ise azaldığı ifade edilmektedir.

🔖

Cite This Article

AS, N., DÜNDAR, T., BÜYÜKSARI, Ü. (2022). Effects of knots on the physical and mechanical properties of wood. İstanbul Üniversitesi Orman Fakültesi Dergisi Seri B, Cilt: 58 - Sayı: 2, 1–13. https://ajindex.com/articles/554621

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (16)

  1. As, N., Y. Göker, T. Dündar, 2006. Effect of knots on the physical and mechanical properties of scots pine {Pinus sylvestris L.). Wood Research 51(3):51-58.
  2. Berkel, A., 1970. Ağaç Malzeme Teknolojisi. İ.Ü. Yayın No: 1448, O. F. Yayın No: 117, İstanbul.
  3. Bozkurt, A.Y., Y. Göker, 1987. Fiziksel ve Mekanik Ağaç Teknolojisi. İ.Ü. Yayın No:3445, O.F. Yayın No: 388, İstanbul.
  4. Bozkurt, A.Y., N. Erdin, 1997.
  5. Ağaç Teknolojisi, İ.Ü. Yayın No: 3998, O.F. Yayın No: 445, İstanbul.
  6. Bozkurt, A.Y., N. Erdin, 2000. Odun Anatomisi. İ.Ü. Yayın No: 4263, O.F. Yayın No: 466, İstanbul.
  7. Chui, Y.H., 1991. Simultaneous evaluation of bending and shear moduli of wood and the influence of knots on these parameters. Wood Sci. and Tech. 25:125-134.
  8. Graff, O., 1938. Dauerversuche mit Holzverbindungen. Mitt. Fachaussch. Holzfragen beim VD, H.22. Grant, D.J., A. Anton, P. Lind, 1984. Bending strength, stiffness and stres-grade of structural pinus radiata: Effect of knots and timber density. New Zeland J. of Forestry Sci. 14(3):331-348.
  9. Gupta, R., C. Basta, S.M. Kent, 2004. Effect of knots on longitudinal shear strength of douglas-fir using shear blocks. Forest Prod. J. 54 (ll):77-83.
  10. Gurfinkel, G., 1973. Wood Engineering. Southern Forest Products Association, New Orleans. Kollmann, F.F.P., W.A. Cote, 1968. Principles of Wood Science and Technology, I. Solid Wood. Springer Verlag, Berlin. Pellicane, P.J., K.S. Mcmillan, RJ. Ticky, 1987. Effects of knots near the fingers of finger-jointed dimension lumber. Forest Prod. J. 37(5): 13-16.
  11. Phillips, G.E., J. Bodig, J.R. Goodman, 1981. Flow-grain anology. Wood Sci. 14:55-64.
  12. Rajput, S.S., V.K. Gupta, R.C. Lohani, 1980. A study of effect of knot on the strength of timber. Journal of the Indian Academy of Wood Sci. 11(1):8-15.
  13. Takeda, T., T. Hashizume, 1999. Differences of tensile strength distribution between mechanically high-grade and low-grade Japanese larch lumber II: Effect of knots on tensile strength distribution. Journal of Wood Sci. 45(3):207-212.
  14. Xu, P., 2002. Estimating the influence of knots on the local longitudinal stiffness in radiata pine structural timber. Wood Science and Technology 36: 501-509
  15. Wandt, R., 1937.
  16. Mitt. Forstwirtsch, Fortwiss, 8.