Journals / International Journal of Pure and Applied Sciences / 2022 / Cilt: 8 - Sayı: 1

Modelling and Optimization of Indigo Carmine Adsorption onto P(NIPAM-co-AN)/Clay Composite Using Response Surface Methodology

Cevap Yüzey Metodolojisi Kullanılarak P(NIPAM-co-AN)/Kil Kompozit Üzerine İndigo Karmin Adsorpsiyonunun Modellenmesi ve Optimizasyonu

Pages
71–80
Publication Date
2022-10-19
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Based on the ANOVA statistical value, the adsorption of indigo carmine onto P(NIPAM-co-AN)/clay composite is highly significant, with very low probability value (p

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In the present work, a new polymeric adsorbent; Poly(NIPAM-co-AN)/clay composite was prepared via in-situ polymerization.
📊
Key Findings & Data:The copolymerization of N-isopropylacrylamide, acrylonitrile and calculated clay (about 5% w/w) were carried out at 65°C in the presence of 10 mL 1,4-dioxane using AIBN as an initiator.
💡
Conclusion & Impact:Based on the ANOVA statistical value, the adsorption of indigo carmine onto P(NIPAM-co-AN)/clay composite is highly significant, with very low probability value (p
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Adsorpsiyon · polimerik adsorban · Cevap Yüzey Yöntemi

Abstract

In the present work, a new polymeric adsorbent; Poly(NIPAM-co-AN)/clay composite was prepared via in-situ polymerization. The copolymerization of N-isopropylacrylamide, acrylonitrile and calculated clay (about 5% w/w) were carried out at 65°C in the presence of 10 mL 1,4-dioxane using AIBN as an initiator. Characterization of P(NIPAM-co-AN)/clay composite was determined by FT-IR techniques. NIPAM-AN/clay composite has been used as a novel adsorbent to remove indigo carmine dye from synthetic effluents. Three important process parameters i.e., initial IC concentration (5-30 mg/L), adsorbent dosage (0.01-0.08 g) and contact time (10–180 min) were modeled and optimized to get the best response of indigo carmine removal using a Central Composite Design assembled with Response Surface Methodology. The amount of indigo carmine in the solution was measured using a UV-visible spectrophotometer at a wavelength of 650 nm. Based on the ANOVA statistical value, the adsorption of indigo carmine onto P(NIPAM-co-AN)/clay composite is highly significant, with very low probability value (p

Özet

Bu çalışmada yeni bir polimerik adsorban olan Poli(NIPAM-co-AN)/kil kompoziti yerinde polimerizasyon ile hazırlanmıştır. N-izopropilakrilamid, akrilonitril ve uygun miktarda alınan kilin (yaklaşık %5 w/w) kopolimerizasyonu, 10 mL 1,4-dioksan varlığında 65°C'de, AIBN (azobisizobütironitril) başlatıcısı varlığında gerçekleştirildi. NIPAM-AN/kil kompoziti IC (indigo karmin) boyasını sentetik atık sulardan uzaklaştırmak için yeni bir adsorban olarak kullanılmıştır. Üç önemli proses parametresi olan başlangıç indigo karmin konsantrasyonu (5-30 mg/L), adsorban dozu (10-80 mg) ve temas süresi (10-180 dakika) yanıt yüzeyi metodolojisi (RSM) ile birleştirilmiş. Merkezi Kompozit Tasarım (CCD) kullanılarak modelleme yapıldı ve en iyi indigo karmin giderme yanıtını elde etmek için optimize edildi. Çözeltideki indigo karmin miktarı, 650 nm dalga boyunda bir UV-görünür spektrofotometre kullanılarak ölçülmüştür. ANOVA (varyans analizi) istatistiksel değerine dayalı olarak, indigo karminin P(NIPAM-co-AN)/kil kompoziti üzerine adsorpsiyonu, çok düşük olasılık değeriyle (p

🔖

Cite This Article

PIHTILI, G., TANYOL, M. (2022). Modelling and Optimization of Indigo Carmine Adsorption onto P(NIPAM-co-AN)/Clay Composite Using Response Surface Methodology. International Journal of Pure and Applied Sciences, Cilt: 8 - Sayı: 1, 71–80. https://ajindex.com/articles/541499

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (9)

  1. Arslan-Alaton, İ., Ölmez-Hancı, T., Karahan, Pala, İ. ve Orhon, D. (2011). Yüzey aktif maddelerin ileri oksidasyon prosesleri ile arıtımı: Proses optimizasyonu ve toksisite analizi. İtüdergisi/e, 21 (1), 69-80.
  2. Batur E., Baytar O., Kutluay S., Horoz S., Şahin Ö. (2021). A comprehensive new study on the removal of Pb (II) from aqueous solution by şırnak coal-derived char. Environmental Technology, 42, (3), 505–520.
  3. Boudechiche, N., Fares, M., Ouyahia, S., Yazid, H., Trari, M. and Sadaoui, Z. (2019). Comparative study on removal of two basic dyes in aqueous medium by adsorption using activated carbon from Ziziphus lotus Stones. Microchemical Journal, 146, 1010-1018.
  4. Cestari, A.R., Vieira E.F.S.,Tavares A.M.G., Bruns R.E. (2008). The removal of the indigo carmine dye from aqueous solutions using cross-linked chitosan—Evaluation of adsorption thermodynamics using a full factorial design. Journal of Hazardous Materials, 153: 566–574.
  5. Chawla P., Sharma, S.K. and Toor, A.P. (2019). Optimization and modeling of UV-TiO2 mediated photocatalytic degradation of golden yellow dye through response surface methodology. Chemical Engineering Communications, 206 (9), 1123-1138.
  6. Dil, E. A., Ghaedi, M. and Asfaram, A. (2017). The performance of nanorods material as adsorbent for removal of azo dyes and heavy metal ions: application of ultrasound wave, optimization and modeling. Ultrasonics Sonochemistry, 34, 792–802. Ece M. Ş, Kutluay S. Şahin Ö. and Horoz S. (2020). Development of Novel Fe3O4/AC@SiO2@1,4-DAAQ Magnetic Nanoparticles with Outstanding VOC Removal Capacity: Characterization, Optimization, Reusability, Kinetics, and Equilibrium Studies. Industrial & Engineering Chemistry Research, 59 (48), 21106-21123. Ece M. Ş, Kutluay S., Şahin Ö. (2021). Silica-coated magnetic Fe3O4 nanoparticles as efficient nano-adsorbents for the improvement of the vapor-phase adsorption of benzene. International Journal of Chemistry and Technology, 5 (1), 33-41.
  7. Harrache, Z., Abbas, M., Aksil, T., Mohamed, M. (2019). Thermodynamic and kinetics studies on adsorption of Indigo Carmine from aqueous solution by activated carbon. Microchemical Journal,144:180–189.
  8. Kumar, R., Singh, R., Kumar, N., Bishnoi, K. and Bishnoi, N. (2009). Response surface methodology approach for optimization of biosorption process for removal of Cr (VI), Ni (II) and Zn (II) ions by immobilized bacterial biomass sp. Bacillus brevis. Chemical Engineering Journal, 146, 401-407.
  9. Kutluay S., Ece M. Ş, Şahin Ö. (2020