Journals / Teknik Dergi / 2020 / Cilt: 31 - Sayı: 3

Vertical Stress Distribution in Reinforced Sandy Soil in Plane Strain Conditions

Donatılı Kum Zeminlerde Düzlem Deformasyon Koşullarında Düşey Gerilme Dağılışı

Pages
9967–9985
Publication Date
2020-05-01
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

However, the methods based on elasticity theory give rather erroneous results in low relative density reinforced soil.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Development of technology gives the opportunity to mankind to build larger, heavier and more complex structures.
📊
Key Findings & Data:Subsequently, the experimental setup was modelled with PLAXIS 2D and vertical stress increments were obtained with Mohr-Coulomb model.
💡
Conclusion & Impact:However, the methods based on elasticity theory give rather erroneous results in low relative density reinforced soil.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Düşey gerilme artışı · basınç ölçer · donatılı zemin

Abstract

Development of technology gives the opportunity to mankind to build larger, heavier and more complex structures. For geotechnical engineers, faced with transferring the loads that is more complex and increasing, stabilization of soil, and determination of stress distribution and settlement has become inevitable. Geotextiles which have been used in soil stabilization increasingly in recent years affect bearing capacity of soil. Stress distribution in terms of settlement calculation and bearing capacity are some of the most important parameters for foundation design. In this study, several tests were carried out with model strip footing in plane strain conditions in reinforced cohesionless soil and the vertical stress increments occurred in the soil medium due to applied vertical surface loads were determined at several specific locations. In scope of experimental study, the sand reinforced with geotextile sheet was placed in layers in a tank with three different relative densities and vertical stress increments were measured by pressure gauges placed at predetermined locations. Subsequently, the experimental setup was modelled with PLAXIS 2D and vertical stress increments were obtained with Mohr-Coulomb model. Additionally vertical stress distribution in soil was calculated with analytical methods (Poulos and Boussinesq) based on elasticity theory. As the findings obtained from these studies were examined, it was understood that relative density is a very effective parameter for stress distribution in soils. However, the methods based on elasticity theory give rather erroneous results in low relative density reinforced soil.

Özet

Teknolojinin gelişmesi insanoğluna daha geniş, daha ağır ve daha karmaşık yapılar yapma fırsatı vermiştir. Artan ve karmaşık hale gelen yükleri zemine aktarma problemi ile karşılaşan geoteknik mühendisleri için; zemini iyileştirmek, zeminde meydana gelecek oturmaları ve gerilme dağılışlarını tespit etmek kaçınılmaz hale gelmiştir. Son yıllarda zemini iyileştirmede kullanımı artan bir yapı malzemesi olan geotekstiller, zeminlerin taşıma gücünü etkilemektedir. Zeminde meydana gelecek oturmalar açısından gerilme dağılışı ve taşıma gücü temel tasarımının en önemli parametrelerden birkaçıdır. Bu çalışmada donatılı kum zemin yüzeyine oturan model şerit temelle düzlem deformasyon koşullarında deneyler yapılmış ve uygulanan düşey yükten dolayı zeminde belirli noktalarda meydana gelen düşey gerilme artışları tespit edilmiştir. Deneysel çalışma kapsamında, üç farklı rölatif sıkılıkta geotekstille güçlendirilmiş kum tabakalarında, önceden belirlenen noktalara yerleştirilen basınç ölçerler yardımıyla düşey gerilme artışları kaydedilmiştir. Daha sonra model deney düzeneği PLAXIS 2D programı ile modellenip Mohr-Coulomb modeli ile düşey gerilme artışları belirlenmiştir. Ayrıca donatılı zeminin, Elastisite Teorisine dayalı olarak geliştirilen analitik yöntemlerle (Poulos ve Boussinesq) düşey gerilme artışları hesaplanmıştır. Deneylerle elde edilen tüm değerler incelendiğinde, rölatif sıkılığın donatılı zemindeki gerilme dağılışında etkili bir parametre olduğu belirlenmiştir. Bununla birlikte, yaygın kullanılan Elastisite Teorisine dayalı çözümlerin düşük rölatif sıkılıktaki donatılı zeminlerde oldukça hatalı sonuçlar verdiği görülmüştür.

🔖

Cite This Article

ATEŞ, B., ŞADOĞLU, E. (2020). Vertical Stress Distribution in Reinforced Sandy Soil in Plane Strain Conditions. Teknik Dergi, Cilt: 31 - Sayı: 3, 9967–9985. https://ajindex.com/articles/51205

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (14)

  1. Patel, M.M., Influence od Shape of Footing on The Performance of The Reinforced Sand, Proceedings of The Conference on Construction Practices and Instrumentation in Geotechnical Engineering, 265-269, 1982
  2. Fragaszy, R.J. ve Lawton, E., Bearing Capacity of Reinforced Sand Subgrades, Journal of Geotechnical Engineering, ASCE, 110, 10, 1500-1507, 1984
  3. Guido, V.A., Biesiadecki, G.L. ve Sullivan, M.J., Bearing Capacity of a Geotextile Reinforced Foundation, Proceedings of 11th International Conference on Soil Mechanics And Foundation Engineering, San Fransisco, 1777-1780, 1985
  4. Guido, V.A., Chang, D.K. ve Sweeney, M.A., Comparison of Geogrid and Geotextile Reinforced Earth Slabs, Canadian Geotechnical Journal, 23, 435-440, 1986
  5. Khing, K.H., Das, B.M., Puri, V.K., Cook, E.E. ve Yen, S.C., The Bearing Capacity of a Strip Foundation on Geogrid-reinforced Sand, Geotextiles and Geomembranes, 12, 351-361, 1993
  6. Omar, M. T., Das, B. M., Puri, V. K. Yen, S. C., Ultimate bearing capacity of shallow foundations on sand with geogrid reinforcement, Geotechnical Journal, 545-549, 1993
  7. Das, B. M., Shin, E. C., Omar, M. T., The bearing capacity of surface strip foundations on geogrid-reinforced sand and clay-A comparativestudy, Geotechnical and Geological Engineering, 12, 15-33, 1994
  8. Tan, Ö. ve Çelik, S., Geogrid Donatılı Kumlarda Taşıma Gücünün Model Deneylerle Araştırılması, 10. Mühendislik Sempozyumu, Süleyman Demiral Üniversitesi, Bildiriler Kitabı, Isparta, 414-420, 1999
  9. Shin, E.C. ve Das, B.M., Experimental Study of Bearing Capacity of A Strip Foundation on Geogrid Reinforced Sand, Geosynthetics International, 7, 1, 59-71, 2000
  10. Shin, E.C., Das, B.M., Lee, E. S. ve Atalar, C., Bearing Capacity of Strip Foundation on Geogrid-Reinforced Sand, Geotechnical and Geological Engineering, 20, 169-180, 2002
  11. Patra, C.R., Das, B.M. ve Atalar, C., Bearing Capacity of Embedded Strip Foundation on Geogrid-Reinforced Sand, Geotextiles and Geomembranes, 23, 5, 454-462, 2005
  12. Patra, C.R., Das, B.M., Bhoi, M. ve Shin, E.C., Eccentrically Loaded Strip Foundation on Geogrid-Reinforced Sand, Geotextiles and Geomembranes, 24, 254-259, 2006
  13. Omar, M.T., Ultimate Bearing Capacity of Eccentrically Loaded Strip Foundation on Geogrid- Reinforced Sand, University of Sharjah Journal of Pure and Applied Sciences, 3, 2, 35-51, 2006
  14. Sadoglu, E., Cure, E., Moroglu, B. ve Uzuner, B. A., Ultimate Loads for Eccentrically Loaded Model Shal