SavedAdd your journal

Journals / Düzce Üniversitesi Bilim ve Teknoloji Dergisi / 2020 / Cilt: 8 - Sayı: 2

The Fracture Toughness and Brittleness of Au doped YBCO Superconductors

Au katkılı YBCO süperiletkenlerin kırılma tokluğu ve kırılganlıkları

Rıfkı TERZİOĞLU
Pages
1562–1570
Publication Date
2022-10-12
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The possible reasons for the observed degradation in the mechanical properties due to Au addition are discussed.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this work, the effect of Au addition on some mechanical properties of YBCO superconductors are analyzed.
📊
Key Findings & Data:Five different samples (undoped, 1%, 5%, 15% and 20%) were prepared using the conventional solid state reaction method.
💡
Conclusion & Impact:The possible reasons for the observed degradation in the mechanical properties due to Au addition are discussed.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Au katkılama · kırılma tokluğu · YBCO

Abstract

In this work, the effect of Au addition on some mechanical properties of YBCO superconductors are analyzed. Five different samples (undoped, 1%, 5%, 15% and 20%) were prepared using the conventional solid state reaction method. The experimental results of the microhardness measurements are used to obtain the yield strength, Young’s modules, fracture toughness and brittleness index. These mechanical properties mentioned above are extracted by using the proportional specimen resistance (PSR) model. The mechanical properties of the samples were found to be load dependent. The yield strength, Young’s modules, brittleness index and fracture toughness values increase with decreasing test load and decreases with increasing Au content. The possible reasons for the observed degradation in the mechanical properties due to Au addition are discussed.

Özet

Bu çalışmada, Au ilavesinin YBCO süper iletkenlerinin bazı mekanik özelliklerine etkisi incelenmiştir. Geleneksel katı hal reaksiyon metodu kullanılarak beş farklı numune (katkısız, % 1, % 5, % 15 ve % 20) hazırlanmıştır. Mikro sertlik ölçümlerinin deneysel sonuçları, akma dayanımı, Young modülleri, kırılma tokluğu ve kırılganlık indeksi elde etmek için kullanılmıştır. Yukarıda belirtilen bu mekanik özellikler PSR modeli kullanılarak elde edilmiştir. Numunelerin mekanik özelliklerinin yüke bağlı olduğu bulunmuştur. Akma dayanımı, Young’s modulus, kırılganlık indeksi ve kırılma tokluğu değerlerinin azalan test yükü ile arttığı ve artan Au içeriği ile azaldığı gözlemlenmiştir. Au ilavesi nedeniyle mekanik özelliklerde gözlenen bozulmanın olası nedenleri tartışılmıştır.

🔖

Cite This Article

TERZİOĞLU, R. (2022). The Fracture Toughness and Brittleness of Au doped YBCO Superconductors. Düzce Üniversitesi Bilim ve Teknoloji Dergisi, Cilt: 8 - Sayı: 2, 1562–1570. https://ajindex.com/articles/494070

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (12)

  1. S. Hahn et al., “Design study on a 100-kA/20-K HTS cable for fusion magnets,” IEEE Trans. Appl. Supercond., vol. 25, no. 3, 2015
  2. G. Celentano et al., “Design of an industrially feasible twisted-stack HTS cable-in-conduit conductor for fusion application,” IEEE Trans. Appl. Supercond., vol. 24, no. 3, 2014
  3. W.H. Fietz, R. Heller, S.I. Schlachter and W. Goldacker, “Application of high temperature superconductors for fusion,” Fusion Engineering and Design, vol. 86, no. 6–8, pp. 1365-1368, 2011
  4. W. Goldacker, F. Grilli, E. Pardo, A. Kario, S. Schlachter and M. Vojenčiak, “Roebel cables from REBCO coated conductors: a one-century-old concept for the superconductivity of the future,” Supercond. Sci. Technol., vol. 27, no. 9, 2014
  5. S. B. Mohamed, S. A. Halim and H. Azhan, “Effect of doping Ba, Y, V, Zn and Sn on BSCCO superconducting ceramics,” IEEE Transactions on Applied Superconductivity, vol. 11, no. 1, 2001
  6. B. P. Mikhailov, G. S. Burkhanov, P. E. Kazin, V. V. Lennikov, S. V. Shavkin, G. V. Laskova and A. A. Titov, “Microstructure and superconducting properties of TaC-doped Bi-2223 ceramics,” Inorganic Materials, vol. 37, no. 11, pp. 1199-1205, 2001
  7. G. Yildirim, “Beginning point of metal to insulator transition for Bi-2223 superconducting matrix doped with Eu nanoparticles,” Journal of Alloys and Compounds, vol. 578, pp. 526-535, 2013
  8. M. Dogruer, Y. Zalaoglu, A. Varilci, C. Terzioglu, G. Yildirim and O. Ozturk, “A study on magnetoresistivity, activation energy, irreversibility and upper critical field of slightly Mn added Bi-2223 superconductor seramics,” J. Supercond. Nov. Magn., vol. 25, pp. 961-968, 2012
  9. G. Yildirim, S. Bal, E. Yucel, M. Dogruer, M. Akdogan, A. Varilci and C. Terzioglu, “Effect of Mn addition on structural and superconducting properties of (Bi, Pb)-2223 superconducting ceramics,” J. Supercond. Nov. Magn., vol. 25, pp. 381-390, 2012
  10. N. Soylu, C.C. Yahsi, S.P. Altintas, S. Nezir and C. Terzioglu, “The structural and electrical study of Lu-doped YBCO system,” J. Supercond. Nov. Magn., vol. 25, pp. 1945-1949, 2013
  11. M.B. Turkoz, S. Nezir, C. Terzioglu, A. Varilci and G. Yildirim, “Investigation of Lu effect on YBa2Cu3O7-delta superconducting compounds,” Journal of Materials Science-Materials in Electronics, vol. 24, no. 3, pp. 896-905, 2013
  12. H. Sozeri, N. Ghazanfari, H. Ozkan and et al., “Enhancement in the high-Tc phase of BSCCO superconductors by Nb addition,” Supercond. Sci. Technol.,