Journals / Cumhuriyet Science Journal / 2022 / Cilt: 43 - Sayı: 2

Influence of the Core Pillar Height on the Bandgap Characteristics of Piezoelectric Phononic Crystals with Ring-Shaped Grooves

Pages
346–350
Publication Date
2022-10-12
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The resonant frequency of the phononic crystals can be tuned by adjusting the core pillar height.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Dispersion profiles and surface acoustic wave attenuation characteristics of ring-shaped phononic crystals are investigated as a function of the core pillar height.
📊
Key Findings & Data:The results reveal that the increase at the core pillar height leads to a decrement in the local resonance band gap frequencies and the corresponding transmission peaks.
💡
Conclusion & Impact:The resonant frequency of the phononic crystals can be tuned by adjusting the core pillar height.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Abstract

Dispersion profiles and surface acoustic wave attenuation characteristics of ring-shaped phononic crystals are investigated as a function of the core pillar height. Finite element method simulations are carried out for both band analyses and transmission spectra calculations. The results reveal that the increase at the core pillar height leads to a decrement in the local resonance band gap frequencies and the corresponding transmission peaks. The obtained dispersion profiles show that the phononic crystal bandgap also expands from 6 MHz to 11 MHz while the pillar height increases from 5 m to 7 m. Similar characteristics are also seen in the transmission spectra for the varying core pillar heights of the ring-shaped periodic grooves. In addition, surface acoustic wave attenuation competency depends on the core pillar height. The resonant frequency of the phononic crystals can be tuned by adjusting the core pillar height.

🔖

Cite This Article

KURUOĞLU, F. (2022). Influence of the Core Pillar Height on the Bandgap Characteristics of Piezoelectric Phononic Crystals with Ring-Shaped Grooves. Cumhuriyet Science Journal, Cilt: 43 - Sayı: 2, 346–350. https://ajindex.com/articles/477492

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (11)

  1. Collins D.J., Devendran C., Ma Z., Ng, J.W., Neild A., Ai Y., Acoustic tweezers via sub–time-of-flight regime surface acoustic waves, Sci. Adv., 2 (7) (2016) e1600089
  2. Topaltzikis D., Wielunski M., Hörner A.L., Küß M., Reiner A., Grünwald T., Schreck M., Wixforth A., Rühm W., Detection of x rays by a surface acoustic delay line in contact with a diamond crystal, Appl. Phys. Lett., 118 (13) (2021) 133501
  3. Su R., Shen J., Lu Z., Xu H., Niu Q., Xu Z., Zeng F., Song C., Wang W., Fu S., Pan F., Wideband and Low-Loss Surface Acoustic Wave Filter Based on 15° YX-LiNbO₃/SiO₂/Si Structure, IEEE Electr. Device L., 42 (3) (2021) 438-441
  4. Su R., Fu S., Shen J., Lu Z., Xu H., Yang M., Zeng F., Song C., Wang W., Pan F., Power Durability Enhancement and Failure Analysis of TC-SAW Filter With Ti/Cu/Ti/Cu/Ti Electrodes, IEEE T. Device Mat. Re., 21 (3) (2021) 365-371
  5. Xie Y., Mao Z., Bachman H., Li P., Zhang P., Ren L., Wu M., Huang T.J., Acoustic Cell Separation Based On Biophysical Properties., J. Biomechanical Eng., 142 (3) (2020) 031005-1-9 [6] Qian J., Ren J., Liu Y., Lam R.H.W., Lee J.E.-Y., A two-chip acoustofluidic particle manipulation platform with a detachable and reusable surface acoustic wave device, Analyst, 145 (23) (2020) 7752-7758
  6. Agostini M., Greco G., Cecchini M., Full-SAW Microfluidics- Based Lab-on-a-Chip for Biosensing, IEEE Access, 7 (2019) 70901-70909
  7. Kumar A., Prajesh R., The Potential of Acoustic Wave Devices for Gas Sensing Applications, Sens. Actuator A-Phys. Physical, 339 (2022) 113498
  8. Hekiem N.L.L., Ralib A.A.M., Hattar M.A. bt M., Ahmad F., Nordin A.N., Rahim,R.A., Za’bah,N.F., Advanced vapour sensing materials, Existing and latent to acoustic wave sensors for VOCs detection as the potential exhaled breath biomarkers for lung cancer, Sens. Actuator A-Phys., 329 (2021) 112792
  9. Wang Y., Wang,., Liu, W., Chen D., Wu C., Xie J., An aerosol sensor for PM1 concentration detection based on 3D printed virtual impactor and SAW sensor, Sens. Actuator A-Phys., 288 (2019) 67-74
  10. Zhang X.-F., Zhang Z.-W., He Y.-L., Liu Y.-X., L, S., Fang J.-Y., Zhang X.-A., Peng G., Sniffing lung cancer related biomarkers using an oxidized graphene SAW sensor Frontiers of Physics, 11 (2015) 2
  11. Kidakova A., Boroznjak R., Reut J., Öpik A., Saarma M., Syritski V., Molecularly imprinted polymer-based SAW sensor for label-free detection of cerebral dopamine neurotrophic factor protein, Sens. Actuator B-Chem., 308 (2020) 127708.