SavedAdd your journal

Journals / Electrica / 2022 / Cilt: 22 - Sayı: 1

Current Reconstruction for PMSM Drives Using a DC-Link Single Current Sensor

Mustafa AKTAŞ
Barış ÇAVUŞ
Journal
Electrica
Pages
101–108
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Performance evaluation of these two methods was made by comparing the integral squared error and total harmonic distortion values of the three phase currents obtained.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:This article presents field-oriented control of permanent magnet synchronous motor (PMSM) with single current sensor (DC-link).
📊
Key Findings & Data:Field-oriented control requires current values flowing from three phases of the motor.
💡
Conclusion & Impact:Performance evaluation of these two methods was made by comparing the integral squared error and total harmonic distortion values of the three phase currents obtained.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Özet

This article presents field-oriented control of permanent magnet synchronous motor (PMSM) with single current sensor (DC-link). Field-oriented control requires current values flowing from three phases of the motor. These currents can be determined by current sensors to be connected to the phases as well as DC-link current sensor to be connected to supply side of invertor. Only one current value is determined by DC-link sensor. In this method, current reconstruction method is used to determine the current flowing from three phases. In this study, two different methods were compared. The mean value method and the least squares method were used to determine the current flowing through three phases using the current value measured from the DC-link current sensor. Performance evaluation of these two methods was made by comparing the integral squared error and total harmonic distortion values of the three phase currents obtained.

🔖

Cite This Article

AKTAŞ, M., ÇAVUŞ, B. (2022). Current Reconstruction for PMSM Drives Using a DC-Link Single Current Sensor. Electrica, Cilt: 22 - Sayı: 1, 101–108. https://ajindex.com/articles/418653

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (13)

  1. O. Saadaoui, A. Khlaief, A. Chaari and M. Boussak, “A new approach rotor speed estimation for PMSM on sliding mode observer,” J. Autom. Syst. Eng., vol. 9, pp. 66–78, 2015
  2. L. Harnefors, S. E. Saarakkala and M. Hinkkanen, “Speed control of electrical drives using classical control methods,” IEEE Trans. Ind. Appl., vol. 49, no. 2, pp. 889–898, 2013
  3. M. Abassi, A. Khlaief, O. Saadaoui, A. Chaari and M. Boussak, “Performance analysis of FOC and DTC for PMSM drives using SVPWM technique,” in 2015 16th Int. Conf. Sci. Tech. Autom. Control Comput. Eng. (STA), Monastir, Tunisia, 2015, pp. 228–233
  4. V. M. Bida, D. V. Samokhvalov and F. S. Al-Mahturi, “PMSM vector control techniques: A survey.” in 2018 IEEE Conference of Russian Young Researchers in Electrical and Electronic Engineering, Moscow, 2018, pp. 577–581
  5. A. Kronberg, “Design and Simulation of Field Oriented Control and Irect Torque Control for a Permanent Magnet Synchronous Motor with Positive Saliency,” M.S. thesis, Maj., Uppsala University, Uppsala, Sweden, 2012
  6. M. Sebba, S. Hassaine, S. Moreau and A. Chaker, “Analyse et synthèse d’une structure de contrôle vectoriel simplifiée associée au couple de charge appliquée au moteur synchrone à aimant permanents,” Acta Electrotechn., vol. 50, no. 2, 2009
  7. G. Chandaka and G. Prasanth, “Direct torque control and field oriented control of PMSM using SVPWM Technique,” Int. J. Adv. Res. Sci. Eng., vol. 3, no. 11, pp. 274–283, 2014
  8. Z. Boulghasoul, A. Elbacha and E. Elwarraki, “Performance of Fuzzy Anti Windup Compensator for PI Type Speed Controller in IM Drives,” in The 2nd International Conference on Industriel Systems and Logisitics, 2010
  9. Z. Boulghasoul, A. Elbacha, E. Elwarraki and D. Yousfi, “Combined Vector Control and Direct Torque Control and Experimental Review and Evaluation,” in International Conference on Multimedia Computing and Systems, 2011, pp. 1–6
  10. F. Blashke, “A new method for the structural decoupling of a A.C. induction machines,” in Conf. Rec. IFAC, 1971, pp. 1–15
  11. D. Casadei, F. Profurno, G. Serra and A. Tani, “FOC and DTC: Two viable schemes for induction motors torque control,” IEEE Trans. Power Electron., vol. 17, no. 5, pp. 779–787, 2002
  12. B. Wu, “High-Power Converters and AC Drives,” IEEE Press, 2006
  13. Y. Xu, H. Yan, J. Zou, B. Wang and Y. Li, “Zero voltage vector sampling method for PMSM three-phase current reconstruction using single current sensor,” IEEE Trans. Power Electron., vol. 32, no. 5,