This study demonstrated the ability of AQIS as an effective, readily available, and low-cost adsorbent for removal of the Pb+2 removal from its aqueous solutions.
📌 3 Key Takeaways
🎯
Objective & Hypothesis:The aim of this work was to investigation the applicability of removing Pb+2 from aqueous solutions using acorn (Quercus ithaburensis) shell (AQIS), using batch adsorption process.Various experimental parameters such as adsorbent dose, pH and contact time were studied to observe their effects on the Pb+2 adsorption process.
📊
Key Findings & Data:At optimum values of the above mentioned parameters, more than 90% removal efficiency was obtained within 2 minutes at AQIS amount of 1 g/100 mL, pH range of 2-6 for Pb+2 concentration of 100 mg/L.
💡
Conclusion & Impact:This study demonstrated the ability of AQIS as an effective, readily available, and low-cost adsorbent for removal of the Pb+2 removal from its aqueous solutions.
The aim of this work was to investigation the applicability of removing Pb+2 from aqueous solutions using acorn (Quercus ithaburensis) shell (AQIS), using batch adsorption process.Various experimental parameters such as adsorbent dose, pH and contact time were studied to observe their effects on the Pb+2 adsorption process. At optimum values of the above mentioned parameters, more than 90% removal efficiency was obtained within 2 minutes at AQIS amount of 1 g/100 mL, pH range of 2-6 for Pb+2 concentration of 100 mg/L. This study demonstrated the ability of AQIS as an effective, readily available, and low-cost adsorbent for removal of the Pb+2 removal from its aqueous solutions.
ÇELEBİ, H., GÖK, O. (2017). USE OF AQIS FOR ADSORPTION OF Pb+2 FROM AQUEOUS SOLUTION. Sigma Mühendislik ve Fen Bilimleri Dergisi, Cilt: 35 - Sayı: 1, 69–75. https://ajindex.com/articles/415267
Kim C.S., (2013) Development of hybrid porous heavy metal adsorbents by modification of palm shell activated carbon, PhD Thesis, Department of Chemical Engineering, Universiti Tunku Abdul Rahman, Malaysia
Bediako J.K., Kim S., Wei W., Yun Y.S., (2016) Adsorptive separation of Pb(II) and Cu(II) from aqueous solutions using as-prepared carboxymethylated waste Lyocell fiber, International Journal of Environmental Science and Technology 13 (3), 875-886
Wasewar K.L., Kumar P., et. al., (2010) Adsorption of Cadmium Ions from Aqueous Solution Using Granular Activated Carbon and Activated Clay, Clean-Soil, Air, Water 38 (7), 649-656
Ghazi Mokri H.S., et. al., (2015) Adsorption of C.I. Acid Red 97 dye from aqueous solution onto walnut shell: kinetics, thermodynamics parameters, isotherms, International Journal of Environmental Science and Technology 12, 1401-1408
Kyzas G.Z., Terzopoulou Z., et. al., (2015) Low-cost hemp biomaterials for nickel ions removal from aqueous solutions, Journal of Molecular Liquids 209, 209-218
Li S., Wang C., et. al., (2013) Effects of compotibilizers on composites of acorn shell powder and low density polyethylene, Bioresources 8 (4), 5817-5825
Lopez F.A., Centeno T.A., et. al., (2013) Textural and fuel characteristics of the chars produced by the pyrolysis of waste wood, and the properties of activated carbons prepared from them, Journal of Analytical and Applied Pyrolysis 104, 551-558
Un U.T., Ates F., et. al., (2015) Adsorption of Disperse Orange 30 dye onto activated carbon derived from Holm Oak (Quercus Ilex) acorns: A 3k factorial design and analysis, Journal of Environmental Management 155, 89-96
Örnek A., Özacar M., Şengil İ.A., (2007) Adsorption of lead onto formaldehyde or sulphuric acid treated acorn waste: Equilibrium and kinetic studies, Biochemical Engineering Journal 37, 192-200
Argun M.E., Dursun S., et. al., (2007) Heavy metal adsorption by modified oak sawdust: Thermodynamics and kinetics, Journal of Hazardous Materials 141 (1), 77-85
Ghaedi M., Hossainian H., Montazerozohori M., et. al., (2011) A novel acorn based adsorbent for the removal of brilliant green, Desalination 281, 226-233
El-Latif M.M.A., Ibrahim A.M., El-Kady M.F. (2010), Adsorption Equilibrium, kinetics and thermodynamics of methylene blue from aqueous solutions using biopolymer oak sawdust composite, Journal of American Science 6 (6), 267-283