SavedAdd your journal

Journals / Turkish Journal of Engineering / 2020 / Cilt: 4 - Sayı: 2

WASTE MINERAL OILS RE-REFINING WITH PHYSICOCHEMICAL METHODS

Ufuk Sancar VURAL
Pages
62–69
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

It was observed that the oils obtained had equivalent parameters to base oils.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Refining of waste mineral oils is usually done by distillation or acid/clay methods, or a combination of both.
📊
Key Findings & Data:In this study, waste oil refining was carried out in order to obtain higher efficiency than acid /clay method by using more environmentally friendly physicochemical methods which could be an alternative to acid /clay method and distillation methods.
💡
Conclusion & Impact:It was observed that the oils obtained had equivalent parameters to base oils.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Waste Mineral Oil · Recycling · Re-refining

Abstract

Refining of waste mineral oils is usually done by distillation or acid/clay methods, or a combination of both. In this study, waste oil refining was carried out in order to obtain higher efficiency than acid /clay method by using more environmentally friendly physicochemical methods which could be an alternative to acid /clay method and distillation methods. For this purpose, demetalization and decolorization stages were applied in order. It was observed that the oils obtained had equivalent parameters to base oils.

🔖

Cite This Article

VURAL, U. S. (2020). WASTE MINERAL OILS RE-REFINING WITH PHYSICOCHEMICAL METHODS. Turkish Journal of Engineering, Cilt: 4 - Sayı: 2, 62–69. https://ajindex.com/articles/370890

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (12)

  1. Abu-Elella, R., Ossman, M.E., Farouq, R., AbdElfatah, M. (2015), “Used motor oil treatment: turning waste oil into valuable products”, International Journal of Chemical and Biochemical Sciences. Vol. 7, pp. 57-67.
  2. Arner, R, (1992). “Used Oil Recycling Markets and Best Management Practice in the United States”, Presented to the National Recycling Congress, Boston, USA. Arpa, O., Yumrutas, R., Demirbas, A. (2010). “Production of diesel-like fuel from waste engine oil by pyrolytic distillation”, Appl Energy, Vol. 87, pp. 122-127.
  3. Bhushan, Z. K., Anil, S. M., Sainand, K., Shivkumar, H. (2016). “Comparison between Different Methods of Waste Oil Recovery”, International Journal of Innovative Research in Science, Engineering and Technology. Vol. 5, No. 11, pp. 2001-2009.
  4. Boadu, K. O., Joel, O. F., Essumang, D. K. and Evbuomwan, B. O., (2019). “A Review of Methods for Removal of Contaminants in Used Lubricating Oil”, Chemical Science International Journal, Vol. 26, No. 4, pp. 1-11
  5. Bridjanian, H., Sattarin, M. (2006). “Modern recovery methods in used oil rerefining”, Petrol Coal Vol. 48, pp. 40–43.
  6. Diphare, M. J., Muzenda, E., Pilusa, I. J., Mollagee, M., (2015). “A Comparison of Waste Lubricating Oil Treatment Techniques”, 2nd International Conference on Environment, Agriculture and Food Sciences (ICEAFS'2013) August 25-26, Kuala Lumpur (Malaysia) Diran, B. (1997). “The Little Adsorption Book: A Practical Guide for Engineers and Scientists”. CRC Press,
  7. Boca Raton, FL, USA. Durrani, H.A. (2014). “Re-Refining Recovery methods of used lubricating oil”, International Journal of Engineering Sciences & Research Technology. Vol. 3, No. 3, pp. 1216-1220.
  8. Giovanna, F. D., Khlebinskaia, O., Lodolo, A. and Miertus, S. (2003). “Compendium of Used Oil Regeneration Technologies”, International Centre for Science and High Technology of the United Nations Industrial Development Organization (ICS-UNIDO), Trieste. 1-210
  9. Hamad, A., Al-Zubaidya, E., Muhammad, E.F. (2005). “Used lubricating oil recycling using hydrocarbon solvents”, Environ. Manage. Vol. 74, pp. 153–159.
  10. Hamawand, I., Yusaf, T., Rafat, S. (2013), “Recycling of waste engine oils using a new washing agent”, Energies. pp.1023-1049.
  11. Hani, F. B., Al-Wedyan, H. (2011), “Regeneration of Base-Oil from Waste-Oil under Different Conditions and Variables”, African Journal of Biotechnology”, pp. 1150-1153.
  12. Havemann, R. (1978), “The KTI used oil re-refining process”. In Proceedings of the 3rd International Conference of Used Oil R