Journals / Politeknik Dergisi / 2008 / Cilt: 11 - Sayı: 1

The Effect of the Form of Chip Breaker on Tool Wear and Surfaces Roughness During Machining of AISI 316 Austenitic Stainless Steel

AISI 316 Östenitik Paslanmaz Çeliğin İşlenmesinde Talaş Kırıcı Formunun Takım Aşınmasına ve Yüzey Pürüzlülüğüne Etkisi

Pages
13–17
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

It was observed that one of the cutting tools with chip breaker ERGC type gave better wear results

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this study, when machining AISI 316 stainless steel with and end mill the influence of cutting tool chip breakers on tool wear and surface roughness have been investigated.
📊
Key Findings & Data:In the process of machining three different chip breakers form and three different cutting speeds (180, 225, 270 m/min) by keeping the dept of cut constant.
💡
Conclusion & Impact:It was observed that one of the cutting tools with chip breaker ERGC type gave better wear results
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Paslanmaz çelik · Takım aşınması · Yüzey pürüzlülüğü

Abstract

In this study, when machining AISI 316 stainless steel with and end mill the influence of cutting tool chip breakers on tool wear and surface roughness have been investigated. In the process of machining three different chip breakers form and three different cutting speeds (180, 225, 270 m/min) by keeping the dept of cut constant. It was observed that one of the cutting tools with chip breaker ERGC type gave better wear results

Özet

Bu çalışmada, AISI 316 paslanmaz çeliğin takma uçlu parmak freze ile işlenirken, kullanılan kesici uç üzerindeki talaş kırıcı formun kesici kenar üzerindeki aşınmaya ve yüzey pürüzlülüğüne etkisi incelenmiştir. Bunun için kesme derinliği sabit tutularak, üç değişik talaş kırıcı formlu takım ve üç farklı kesme hızı (180, 225, 270 m/min) kullanılmıştır. Yapılan deneysel çalışmada, kullanılan kesici takımlardan ERGC kodlu takımın diğer takımlardan daha iyi aşınma ve yüzey pürüzlülüğü sonuçları verdiği ortaya çıkmıştır.

🔖

Cite This Article

ALTINKAYA, E., GÜLLÜ, A. (2008). The Effect of the Form of Chip Breaker on Tool Wear and Surfaces Roughness During Machining of AISI 316 Austenitic Stainless Steel. Politeknik Dergisi, Cilt: 11 - Sayı: 1, 13–17. https://ajindex.com/articles/307225

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...