Journals / Research on Engineering Structures and Materials / 2021 / Cilt: 7 - Sayı: 1

Experimental low cycle fatigue testing of circular bars with radial through-holes subjected to tension-compression loading

Pages
87–95
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

In the worst case, the introduction of a radial hole resulted in an average fatigue life reduction factor of more than two orders of magnitude.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:The aim of this experimental testing was to assess how the introduction of features such as holes into a component under severe variable loading can result in low cycle fatigue (LCF) behaviour.
📊
Key Findings & Data:Although not strictly applicable in situations where significant plasticity occurs, such as in LCF behaviour, further planned studies might show how Kt can be used as a guide for similar components and loadings with other types of notches.
💡
Conclusion & Impact:In the worst case, the introduction of a radial hole resulted in an average fatigue life reduction factor of more than two orders of magnitude.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters

Özet

The aim of this experimental testing was to assess how the introduction of features such as holes into a component under severe variable loading can result in low cycle fatigue (LCF) behaviour. Circular bars with a range of radial throughhole diameters were subjected to severe cyclic axial loading until failure occurred. Relationships between the hole diameter, the loading and the number of cycles to failure are shown graphically. Results are also presented using the elastic stress concentration factor (Kt) as the independent variable. Although not strictly applicable in situations where significant plasticity occurs, such as in LCF behaviour, further planned studies might show how Kt can be used as a guide for similar components and loadings with other types of notches. Low cycle fatigue lives in the range 161 to 5280 cycles, for the largest hole/highest load and the smallest hole/lowest load combinations respectively, were observed. The lower value is approaching the ultra-low cycle fatigue (ULCF) regime. In the worst case, the introduction of a radial hole resulted in an average fatigue life reduction factor of more than two orders of magnitude.

🔖

Cite This Article

HARDY, S. J., SATSAVİA, H. (2021). Experimental low cycle fatigue testing of circular bars with radial through-holes subjected to tension-compression loading. Research on Engineering Structures and Materials, Cilt: 7 - Sayı: 1, 87–95. https://ajindex.com/articles/302586

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (8)

  1. Sachs NW. Practical plant failure analysis: a guide to understanding machinery deterioration and improving equipment reliability, 2nd edition, Boca Raton CRC Press Taylor and Francis Group, 2019, ISBN 13:978 – 1 – 138 – 32411 – 4
  2. Dowling NE, Brose WR, Wilson WK. Notched member fatigue life prediction by the local strain approach. Advances in Engineering, 1977, 6: 55-84
  3. Topper TH, Gowda CVBG. Local stress/strain approach to fatigue analysis and design. ASME Design engineering conference and show, Paper 70-DE-24, Chicago, 1970
  4. Agrawal R, Uddanwadiker R, Padole P. Low cycle fatigue life prediction. Int J Emerging Engineering Research and Technology, 2014, 2(4): 5-15
  5. Gowhari-Anaraki AR, Hardy SJ, Pipelzadeh MK. Experimental and analytical fatigue data for notched shafts in bending. Jurnal Kejuruteraan (University Kebangsaan Malaysia), 2003, 15: 15-31
  6. Dundulis G, Janulionis R, Grybenas A, Makarevicius V, Dundulis R. Numerical and experimental investigation of low cycle fatigue behaviour in P91 steel. Eng Failure Analysis, 2017, 79: 285-295.
  7. Beesley R, Chen H, Hughes M. A novel simulation for the design of a low cycle fatigue experimental testing programme. Computers and Structures, 2017, 178: 105-118.
  8. Pereira JCR, de Jesus AMP, Xavier J, Fernandes AA. Ultra low-cycle fatigue behaviour of a structural steel. Eng Structures, 2014, 60: 214-222. https://doi.org/10.1016/j.engstruct.2013.12.039