It is shown that the Nusselt numbers calculated for the four examples cited depend not only on duct shape but also on wall friction.
📌 3 Key Takeaways
🎯
Objective & Hypothesis:This article considers the effect of duct shape on the Nusselt number.
📊
Key Findings & Data:In order to show the effects of duct shape on the Nusselt number, four illustrative examples are given: the heat transfer in a duct of rectangular cross-section, heat transfer in a duct of semicircular cross-section, the heat transfer in a duct of circular cross-section and heat transfer between two parallel plates.
💡
Conclusion & Impact:It is shown that the Nusselt numbers calculated for the four examples cited depend not only on duct shape but also on wall friction.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Domain Parameters
Abstract
This article considers the effect of duct shape on the Nusselt number. In order to show the effects of duct shape on the Nusselt number, four illustrative examples are given: the heat transfer in a duct of rectangular cross-section, heat transfer in a duct of semicircular cross-section, the heat transfer in a duct of circular cross-section and heat transfer between two parallel plates. The method used in this paper is general and it can be applied al flows. It is not necessary to use thin plate analogy, first, the velocity distribution is obtained and then the temperature distribution is found. It is shown that the Nusselt numbers calculated for the four examples cited depend not only on duct shape but also on wall friction.
🔖
Cite This Article
ERDOĞAN, M. E., İMRAK, C. E. (2005). The effects of duct shape on the Nusselt number. Mathematical and Computational Applications, Cilt: 10 - Sayı: 1, 79–88. https://ajindex.com/articles/280360
S.H. Clark and W.M. Kays, Laminar flow forced convection in rectangular tubes,Trans. ASME 75, 859-866, 1953. 2.S.M. Marco and L.S. Han, A note on limiting laminar Nusselt number in ducts with constant temperature gradient by analogy to thin plate theory, Trans. ASME 77, 625- 630,1955. 3.S. Goldstein (Ed.), Modern Developments in Fluid Dynamics,Vol.2, second edn., Roder Pub., New York, 1965. 4.E.R.G. Eckert, T.P.Jr. Irwin and J.T. Yen, Local laminar heat transfer in wedge-shaped passages, Trans. ASME 80, 1433-1438, 1958. 5.E.R. Sparrow and A. Haji-Sheikh, Laminar heat transfer and pressure drag in isoceles triangular, right triangular and circular sector ducts, Trans. ASME 87,426-427,1965. 6.H.M. Soliman, B.B. Munis and B.C. Trap, Laminar flow in the entrance region of circular sector ducts, Trans. ASME, J. Appl. Mech. 49, 640-642, 1982. 7.J.H. Mashliyah, On laminar flow in curved semicircular ducts, J, Fluid. Mech. 99,469-479, 1980. 8.S. Kakaç, R.K. Shah and W. Anng (Eds), Handbook of single-phase convective heat transfer, John Wiley & Sons, New York, 1987.