SavedAdd your journal

Journals / Kastamonu Üniversitesi Orman Fakültesi Dergisi / 2020 / Cilt: 20 - Sayı: 2

Biological Performance of Wood Modified with Orthophthalic Polyester Resin and Styrene

Ortoftalik Poliester Reçinesi ve Stiren ile Modifiye Edilmiş Odunun Biyolojik Performansı

SAİP NAMİ KARTAL
Ömer KANTOĞLU
Pages
97–106
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

Results showed that after modifications, the specimens showed increased resistance against the fungi and termites considering untreated control specimens.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:Aim of study: This study evaluated the improvements in dimensional stability and biological resistance of wood against fungal degradation, and termites by radiation-induced in situ copolymerization of three types of low viscosity-unsaturated polyester resin with styrene.
📊
Key Findings & Data:Material and methods: Radiation polymerization of unsaturated polyester resin with styrene in a viscous system was performed at ambient temperature using gamma (γ)-rays.
💡
Conclusion & Impact:Results showed that after modifications, the specimens showed increased resistance against the fungi and termites considering untreated control specimens.
🔬Design:Research Article
📍Scope:Comprehensive Sample
⚙️Variables:Irradiation · Polymerization · Unsaturated polyester

Abstract

Aim of study: This study evaluated the improvements in dimensional stability and biological resistance of wood against fungal degradation, and termites by radiation-induced in situ copolymerization of three types of low viscosity-unsaturated polyester resin with styrene. Material and methods: Radiation polymerization of unsaturated polyester resin with styrene in a viscous system was performed at ambient temperature using gamma (γ)-rays. In the study, water absorption and dimensional stability of the modified wood specimens were first determined. The wood specimens were also tested against decay and mold fungi and termites in laboratory. Main results: Results after 24-h water immersion of modified wood specimens showed that more than 70% of water repellent effectiveness was obtained in the wood specimens after modifications with the three formulations of tested chemical mixtures; however, the highest anti-swell efficiency values were observed in the specimens treated with the only one type of treating mixtures. Mold resistance tests showed that the treating mixtures tested were not completely inhibited mold growth; however, some improvements in mold scores were seen when compared to control wood specimens. Results showed that after modifications, the specimens showed increased resistance against the fungi and termites considering untreated control specimens. Highlights: Modifications by styrene and UP resin with different formulations and gamma irradiation greatly improved water absorption and volumetric swell of test specimens in comparison with unmodified control specimens.

🔖

Cite This Article

KARTAL, S. N., KANTOĞLU, Ö. (2020). Biological Performance of Wood Modified with Orthophthalic Polyester Resin and Styrene. Kastamonu Üniversitesi Orman Fakültesi Dergisi, Cilt: 20 - Sayı: 2, 97–106. https://ajindex.com/articles/271598

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (9)

  1. ASTM D 4445-10 (2012). Standard Test Method for Fungicides for Controlling Sapstain and Mold on Unseasoned Lumber (Laboratory Method), Destination D4445-10, Virginia Polytechnic Institute pursuant to License Agreement. Aziz, S. H., Ansell, M. P., Clarke, S. J., & Panteny, S. R. (2005). Modified Polyester Resins for Natural Fibre Composites. Composites Science and Technology, 65, 525–535.
  2. Baki, H., Yalcin, O. & Hakki, A. (1993). Improvement of Wood Properties by Impregnation with Macromonomeric Initiators. Journal of Applied Polymer Science, 47, 1097. Borysiak, S. A. (2010). Study of Transcrystallinity in Polypropylene in The Presence of Wood Irradiated with Gamma Rays. Journal of Thermal Analysis and Calorimetry, 101, 439–45.
  3. Cao, X. & Lee, L. J. (2003). Control of Shrinkage and Residual Styrene of Unsaturated Polyester Resins Cured at Low Temperatures: I. Effect of Curing Agents. Polymer, 44, 1893-1902.
  4. Chawla, J. S. (1985). Degradation of Ligno-Cellulose Biomass. Holzforschung und Holzverwertung, 37(2), 101-105.
  5. Despot, R, Hasan, M, Rapp, A. O, Brischke, C, Humar, M, Welzbacher, C.R and Ražem, D. (2012). Changes in Selected Properties of Wood Caused by Gamma Radiation. Gamma Radiation, F. Adrovic, Ed., Intech, 281-304.
  6. Devi, R. R., Ali, I. and Maji, T. K. (2003). Chemical Modification of Rubber Wood with Styrene in Combination with a Crosslinker: Effect on Dimensional Stability and Strength Property. Bioresource Technology, 88, 185-188
  7. Dholakiya, B. (2012). Unsaturated Polyester Resin for Specialty Applications. in “Polyester,” Hosam El-Din M. Saleh, Ed., Intech Open, 167-202. EN (1997a) EN 113: Wood Preservatives—Test Method for Determining the Protective Effectiveness Against Wood Destroying Basidiomycetes—Determination of the Toxic Values. No: 1-2, European Committee for Standardization, Central Secretariat: rue de Stassart 36, B-1050 Brussels. EN (1997b) EN 84: Wood Preservatives, Accelerated Ageing of Treated Wood Prior to Biological Testing. Leaching Procedure. European Committee for Standardization, Central Secretariat: rue de Stassart 36, B-1050 Brussels. Hill, C. A. S. (2006).
  8. Wood Modification - Chemical, Thermal and Other Processes. Wiley Series in Renewable Resources, Wiley and Sons, Chichester, UK, 260. Ibach, R. and Rowell, R.M. (2013). Lumen modifications. In “Wood Chemistry and Wood Composites,” Second Edition,
  9. R.M. Rowell, Ed., CRC Press Taylor and Francis Group, New York, 599-626. Japanese Standards Association (JIS K) (2004) Japan Ind