INVESTIGATION OF THE EFFECTS OF CONVENTIONAL AND WIPER COATED CARBIDE TOOLS WITH DRY CUTTING ON CUTTING FORCES, SURFACE ROUGHNESS, AND MATERIAL HARDNEES IN TURNING 17-4 PH STAINLESS STEEL
Mustafa Ay(MARMARA UNIVERSITY, FACULTY OF TECHNOLOGY, DEPARTMENT OF MECHANICAL ENGINEERING)
Gültekin Basmacı(Mehmet Akif Ersoy University, The Faculty of Engineering and Architecture, Istanbul-Turkey)
The optimal machinability of 17-4PH stainless steel with coated carbide insert was successfully determined in this study
📌 3 Key Takeaways
🎯
Objective & Hypothesis:In this study, an experimental investigation on cutting forces, surface roughness and the hardness of material after machining in turning of 17-4 PH stainless steel using wiper and conventional insert cutting tools with dry cutting condition werepresented.
📊
Key Findings & Data:The influences of feed rate, depth of cut, and corner radius on surface roughness, cutting force and material hardnesswere examined.
💡
Conclusion & Impact:The optimal machinability of 17-4PH stainless steel with coated carbide insert was successfully determined in this study
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Anova · Taguchi method · wiper and conventional tools
Abstract
In this study, an experimental investigation on cutting forces, surface roughness and the hardness of material after machining in turning of 17-4 PH stainless steel using wiper and conventional insert cutting tools with dry cutting condition werepresented. The influences of feed rate, depth of cut, and corner radius on surface roughness, cutting force and material hardnesswere examined. In order to optimize the turning process, Taguchi optimization method has been used. The influence of each parameter on obtained results was determined by using analysis of variance(ANOVA). The relationship between dependent parameters and independent parameters were modeled by Regression analysis. The optimal machinability of 17-4PH stainless steel with coated carbide insert was successfully determined in this study
Ay, M., Basmacı, G. (2016). INVESTIGATION OF THE EFFECTS OF CONVENTIONAL AND WIPER COATED CARBIDE TOOLS WITH DRY CUTTING ON CUTTING FORCES, SURFACE ROUGHNESS, AND MATERIAL HARDNEES IN TURNING 17-4 PH STAINLESS STEEL. TOJSAT, Volume: 6 Issue: 1. https://ajindex.com/articles/1660221