SavedAdd your journal

Journals / Balkan Journal of Electrical and Computer Engineering / 2017 / Cilt: 5 Sayı: 2

Simulation and Power Flow Control Using Switching’s Method of Isolated Wind-Solar Hybrid Power Generation System with Battery Storage

Emrah Oguz
Hasan Çimen
Yüksel Oğuz
Pages
40–49
Publication Date
2017-09-01
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

When the curves of electrical magnitudes obtained from simulation results were examined, it was determined that no big difference existed in electrical and mechanical magnitudes in parallel to dynamic behavior of the installed hybrid power generation system .

📌 3 Key Takeaways

🎯
Objective & Hypothesis:In this paper, a battery-supported hybrid wind-solar energy generation system with switching power flow control is presented to supply stable electrical power to two laboratories at the Electric & Electronic Engineering Department.
📊
Key Findings & Data:For this purpose, 600W 3-phase permanent magnet synchronous generator (PMSG) based on the wind power generation system (WPGS) and the solar power generation system (SPGS) consisting of 190W 3 pieces mono crystal solar panel were combined to build a 1170W hybrid wind-solar power generation system (HWSPGS).
💡
Conclusion & Impact:When the curves of electrical magnitudes obtained from simulation results were examined, it was determined that no big difference existed in electrical and mechanical magnitudes in parallel to dynamic behavior of the installed hybrid power generation system .
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:Wind power generation · solar power generation · hybrid power generation

Abstract

In this paper, a battery-supported hybrid wind-solar energy generation system with switching power flow control is presented to supply stable electrical power to two laboratories at the Electric & Electronic Engineering Department. For this purpose, 600W 3-phase permanent magnet synchronous generator (PMSG) based on the wind power generation system (WPGS) and the solar power generation system (SPGS) consisting of 190W 3 pieces mono crystal solar panel were combined to build a 1170W hybrid wind-solar power generation system (HWSPGS). T he solar and wind power generation systems were used as the main energy sources while 100 Ah 12V 6 pieces gel jeep cycle accumulator groups were used as the energy storage device to ensure continuity of energy. Also d ynamic modeling and switching power flow control of the battery supported the HWSPGS were performed using Matlab/Simulink in this study. D etermining the switching positions of the charge control unit according to loading and battery charge situations of the HWSPGS, power flow control between the generation unit and consumer was made in planned manner. When the curves of electrical magnitudes obtained from simulation results were examined, it was determined that no big difference existed in electrical and mechanical magnitudes in parallel to dynamic behavior of the installed hybrid power generation system .

🔖

Cite This Article

Oguz, E., Çimen, H., Oğuz, Y. (2017). Simulation and Power Flow Control Using Switching’s Method of Isolated Wind-Solar Hybrid Power Generation System with Battery Storage. Balkan Journal of Electrical and Computer Engineering, Cilt: 5 Sayı: 2, 40–49. https://doi.org/10.17694/bajece.334348

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...

References (27)

  1. Chedid, R. & Rahman, S.(1997). Unit sizing and control of hybrid wind-solar power systems, IEEE Transactions on Energy Conversion, 12(1), pp. 79-85.
  2. Bonanno, F., Consoli, A., Raciti, A., Morgana, B. & Nocera, U.(1999). Transient analysis of integrated diesel/wind/photovoltaic generation systems, IEEE Transactions on Energy Conversion, 14(2), pp. 232-238.
  3. Habib, M. A., Said, S. A. M., El Hadidy, M. A. & Al-Zaharna, I.(1999).Optimization procedure of a hybrid photovoltaic wind energy system, Energy, 24(11), pp. 919-929.
  4. Bayer, H. G. & Christian, L.(1996).A method for the identification of configurations of PV / wind hybrid systems for the reliable supply of small loads, Solar Energy, 57(5), pp. 381-391.
  5. Morgan, T. R., Marshall, R. H. & Brinkworth, B. J.(1997).A refined Simulation program for the sizing and optimization of autonomous hybrid energy systems, Solar Energy, 59, pp. 205-215.
  6. Rajendra, P. A. & Natarajan, E. (2006).Optimization of integrated photovoltaic–wind power generation systems with battery storage, Energy, 31(12), pp. 1943–1954.
  7. Altaş, İ. H. (1993).Control strategies for maximum power tracking and energy utilization of a stand-alone photovoltaic energy system, PhD diss., The University of New Brunswick, Faculty of Engineering, Department of Electrical Engineering, Fredericton, Canada.
  8. Diaf, S., Diaf, D., Belhamel, M., Haddadi, M. & Louche, A.(2007).A methodology for optimal sizing of autonomous hybrid PV/wind system, International Journal of Energy Policy, 35(11), pp. 5708-5718.
  9. Mittal, R., Sandu, K. S. & Jain, D. K.(2010).Battery energy storage system for variable speed driven pmsg for wind energy conversion system, Power Electronics, Drives and Energy Systems,1, pp. 300-304. [10] El Ali, A., Moubayed, N. & Outbib, R. (2007). Comparison between solar and wind energy in Lebanon, 9th International Conference on Electrical Power Quality and utilization, pp. 1-5.
  10. Gagliano, S., Neri, D., Pitrone, N., Savalli, N. & Tina, G. (2009). Low-cost solar radiation sensing transducer for photovoltaic systems, WSEAS Transactions on Environment and Development, 5(2), pp. 119-125.
  11. Barsali, S. & Ceraolo, M. (2002). Dynamical Models of Lead-Acid Batteries: Implementation Issues, IEEE Transactions on Energy Conversion, 17(1), pp. 16-23.
  12. Moubayed, N., Kouta, J., El-Ali, A., Dernayka, H. & Outbib, R. (2008). Parameter identification of the lead-acid battery model, 33rd IEEE Photovoltaic Specialists Conference, pp. 1-6.
  13. Onar, O. C., Uzunoglu, M. & Alam, M. S. (2006). Dynamic modeling, design and simulation of a wind/fuel cell/ultra-capacitor-based hybrid power generation system, Journal of Power Sources, 161(1), pp. 707–722.
  14. Thiringer, T. & Linders, J. (1993).Control by variable rotor speed of a fixed-pitch wind turbine operating in a wide speed range, IEEE Transactions on Energy Conversion, 8(3), pp. 520-526.
  15. Molina, M. G. & Juanicó, L. E. (2010). Dynamic modelling and control design of advanced photovoltaic solar system for distributed generation applications, Journal of Electrical Engineering: Theory and Application, 1(3), pp. 141-150.
  16. Valenciaga, F., Puleston, P. F. & Battaiotto, P. E. (2003). Power control of a solar/wind generation system without wind measurement: a passivity/sliding mode approach, IEEE Transactions on Energy Conversion, 18(4), pp. 501-507.
  17. Borowy, B. S. & Salameh, Z. M. (1994). Optimum photovoltaic array size for a hybrid wind/PV system, IEEE Transactions on Energy Conversion, 9(3), pp. 482 – 488.
  18. Bogdan, S. B. & Salameh, Z. M. (1996). Methodology for optimally sizing the combination of a battery bank and PV array in a wind/PV hybrid system, IEEE Transactions on Energy Conversion, 11(2), pp. 367-375.
  19. Elhadidy, M. A. & Shaahid, S. M. (2005). Decentralized /standalone hybrid Wind–Diesel power systems to meet residential loads of hot coastal regions, Energy Conversion and Management, 46(15-16), pp. 2501-2513.
  20. Hajizadeh, A., Tesfahunegn, S. G. & Undeland, T. M. (2011). Intelligent control of hybrid photovoltaic/fuel cell/energy storage power generation system, Journal of Renewable and Sustainable Energy, 3(4), 043112.
  21. Garrison, J. B. & Webber, M. E. (2011). An integrated energy storage scheme for a dispatchable solar and wind powered energy system, Journal of Renewable and Sustainable Energy, 043101.
  22. Bakić, V., Pezo, M., Stevanović, Ž., Živković, M. & Grubor, B. (2012). Dynamical simulation of PV/wind hybrid energy conversion system, The 24th International Conference on Efficiency, Cost, Optimization, Simulation and Environmental Impact of Energy, 45(1), pp. 324–328.
  23. Belfkira, R., Zhang, L. & Barakat, G. (2011). Optimal sizing study of hybrid wind/PV/diesel power generation unit, Solar Energy, 85(1), pp. 100-110.
  24. González, I., Ramiro, A., Calderón, M., Calderón, A. J. & González, J. F. (2012). Estimation of the state-of-charge of gel lead-acid batteries and application to the control of a stand-alone wind-solar test-bed with hydrogen support”, International Journal of Hydrogen Energy, 37 (15), pp. 11090-11103.
  25. Morgan, T. R., Marshall, R. H. & Brinkworth, B. J.(1997).A refined Simulation program for the sizing and optimization of autonomous hybrid energy systems, Solar Energy, 59, pp. 205-215.
  26. Onar, O. C., Uzunoglu, M. & Alam, M. S. (2006). Dynamic modeling, design and simulation of a wind/fuel cell/ultra-capacitor-based hybrid power generation system, Journal of Power Sources, 161(1), pp. 707–722.
  27. Belfkira, R., Zhang, L. & Barakat, G. (2011). Optimal sizing study of hybrid wind/PV/diesel power generation unit, Solar Energy, 85(1), pp. 100-110.