Journals / Politeknik Dergisi / 2026 / Cilt: 11 Sayı: 2

Determining Solidification Isotherms According to Unit Area Approach and Comparing the Results with Actual Solidification Behaviour

Birim Alan Yaklaşımına Göre Katılaşma İzotermlerinin Belirlenmesi ve Gerçek Döküm Koşulları ile Karşılaştırılması

Pages
161–168
Publication Date
2008-06-01
DOI
—
🏛️Bibliographic metadata and full text access for this article are provided via DergiPark.
DergiPark Record ↗
✨

AI Summary & Key Takeaways

AI Insight
⚡ TL;DR(Too Long; Didn't Read)

The results showed that, Unit Area based isotherms closely agreed with actual solidification behaviour.

📌 3 Key Takeaways

🎯
Objective & Hypothesis:The present study compares the solidification isotherms obtained by the Unit Area Approach with the actual solidification profiles.
📊
Key Findings & Data:Decanting method was used for obtaining actual solidification profiles.
💡
Conclusion & Impact:The results showed that, Unit Area based isotherms closely agreed with actual solidification behaviour.
🔬Design:Makale
📍Scope:Comprehensive Sample
⚙️Variables:Birim Alan · Modelleme · Katılaşmanın Modellenmesi.

Abstract

The present study compares the solidification isotherms obtained by the Unit Area Approach with the actual solidification profiles. Decanting method was used for obtaining actual solidification profiles. The results showed that, Unit Area based isotherms closely agreed with actual solidification behaviour. The solidification differences between side and external corner effects of cubes and rectangular prisms, solidification differences between two dimensional and three dimensional sections of cubes and rectangular prisms, and the solidification differences between cylinders and cubes-rectangular prisms are well expressed by the Unit Area based method

Özet

Bu çalışmada farklı geometrilere sahip döküm şekilleri için gerçek katılaşma profilleri ile Birim Alan yaklaşımına göre elde edilen katılaşma izotermleri karşılaştırılmıştır. Gerçek katılaşma profillerinin belirlenmesinde boşaltma döküm yöntemi kullanılmıştır. Sonuçlar incelendiğinde Birim Alan yaklaşımına göre çizilen katılaşma izotermlerinin gerçek katılaşma davranışına oldukça yakın sonuçlar verdiği belirlenmiştir. Birim Alan yaklaşımında küp ve dikdörtgen prizma şekline sahip döküm parçalarda dış kenarlar ile dış köşeler arasındaki soğuma farkları, iki boyutlu döküm kesitleri ile üç boyutu temsil eden köşegen kesitler arasındaki soğuma farkları ve silindir şekilli dökümler ile küp veya dikdörtgen prizma ile arasındaki farklar ortaya çıkarılmıştır.

🔖

Cite This Article

Tüzünalp, K. K., Özdemir, Ş. (2008). Determining Solidification Isotherms According to Unit Area Approach and Comparing the Results with Actual Solidification Behaviour. Politeknik Dergisi, Cilt: 11 Sayı: 2, 161–168. https://ajindex.com/articles/1303089

📄 Full Text PDF Viewer

📄

PDF görüntüleyici hazırlanıyor...