✨
AI Summary & Key Takeaways
AI Insight⚡ TL;DR(Too Long; Didn't Read)
The excess power dumped in resistance can be used for heating purposes.
📌 3 Key Takeaways
🎯
Objective & Hypothesis:In remote location/ far off areas where transmission cost is very high, harnessing of electrical energy from local resources are very much in use.
📊
Key Findings & Data:In this paper modeling, analysis and simulation of Self Excited induction generator at variable loads with Electronic Load Controller is discussed.
💡
Conclusion & Impact:The excess power dumped in resistance can be used for heating purposes.
🔬Design:Modeling & Simulation
📍Scope:Comprehensive Sample
⚙️Variables:— Self Excited induction generator · MATLAB/ SIMULINK · Simpowersystem
Abstract
In remote location/ far off areas where transmission cost is very high, harnessing of electrical energy from local resources are very much in use. In this paper modeling, analysis and simulation of Self Excited induction generator at variable loads with Electronic Load Controller is discussed. The modeling and simulation has been done in simpowersystem block set of MATLAB/ SIMULINK environment. The power in surplus of the consumer load is dumped in a resistance through an ELC. The excess power dumped in resistance can be used for heating purposes.
Keywords
🔖
Cite This Article
TARIQ, M., YUVARAJAN, S. (2013). SIMULINK BASED MODELING, ANALYSIS AND SIMULATION OF SELF EXCITED INDUCTION GENERATOR FOR USE IN REMOTE AREAS. Electrica, Cilt: 13 Sayı: 1, 1623–1628. https://ajindex.com/articles/1017494