Dergiler / Makina Tasarım ve İmalat Dergisi / 2018 / Cilt: 16 - Sayı: 1
An Experimental Investigation of the Ultrasonic-Assisted Machining of Ti-6Al-4V
- Sayfa
- 7–11
- DOI
- —
Özet
In this study, an experimental study was performed for the ultrasonic-assisted turning of Ti-6Al-4V. The surface properties of titanium alloy machined by ultrasonic-assisted turning method were examined. Also, chip morphology was investigated. These measurements were compared with conventional turning operations performed with same cutting parameters. It was seen that ultrasonic-assisted turning affects surface properties. Average surface roughness was reduced, and less deformation was observed on the workpiece surface. Also, serrated and irregular chips were observed.
Abstract
In this study, an experimental study was performed for the ultrasonicassisted turning of Ti6Al4V. The surface properties of titanium alloy machined by ultrasonic-assisted turning method were examined. Also, chip morphology was investigated. These measurements were compared with conventional turning operations performed with same cutting parameters. It was seen that ultrasonic-assisted turning affects surface properties. Average surface roughness was reduced, and less deformation was observed on the workpiece surface. Also, serrated and irregular chips were observed.